Compuprint SP40plus User Manual download pdf (Page 20)

User Manual

MAN10239-01 15

Printer Setup

The Printer Setup is used to configure the printer parameters and to print a Self Test page, to check the

settings and the printer installation, and to perform the Print Offset Tuning.

The default configuration of this printer matches most of the commonly used environments, but it may be

necessary to change some printer parameters.

With this printer you print the forms for the setup, you fill them in, and then you insert them back into the

printer for reading.

Once the printer reads the form, the new values are set.

The following is the complete description of the Setup Procedure.

Entering the Printer Setup Mode

To enter the Printer Setup Mode press and hold the READY key pressed for at least 1 second while

powering the printer on. The printer enters the Setup Mode.

The leds ST1, ST2 and READY are unlit, the DATA led is flashing.

You can now:

Print the Self Test. See “Printing the Self Test” later in this manual.

Print one of the Printer Setup Forms (Configuration Menu or Program1 – Program2 – Program 3 - Program4

Menu) or the Offset Tuning Form. See “Printing the Printer Setup Forms” later in this manual.

Insert a filled-in Printer Setup Form to set the corresponding Setup values.

Printing the Test Page

The Self Test page is useful to test, if the printer has been correctly installed, and allows to see the current

parameter settings.

1. With the printer in the Setup Mode, insert a single sheet in A4 or Letter format.

2. The printer loads the sheet and stops.

3. Press the READY key again.

The printer prints the Self-Test page. Check that the printout is correct. The following printout example shows

the Printer Setup default values.

Once the self-test is finished, the printer remains in Setup Mode.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

No comments

Compuprint SP40plus User Manual Page 20