Compuprint 9070 User Manual download pdf (Page 110)

105

To check the Tear-Off Position proceed as follows:

1. Check if the paper perforation matches the tear-off bar on the printer.

2. To move manually the paper to the Tear-Off position, press the

TEAR

key when the printer is

enabled without printing (TEAR NORMAL function selected

YES

in the Program Setup).

You can leave the manual tear off function by pressing again the

TEAR

key.

If it does not:

1. Turn the printer off and press the

PROGRAM

key and hold it pressed while powering on the

printer until the

RELEASE KEY

message is displayed to enter the Power-On Configuration.

2. Press the ↓ key until the following message appears:

FUNCTIONS

3. Press the → key to enter and then press the ↓ until the following message is displayed:

TEAR ADJUST xxx

4. Press the → or ← key to scroll the values of this function.

The values below 0 move the tear-off position downwards, values above 0 move the paper

upwards. The values can be set between -30 and 360 at 1/180 inches (-1/6 to 2 inches).

5. When the desired value is displayed, press the

PROGRAM

key.

6. Press the

PROGRAM

key to save and exit from the setup.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 170 171

No comments

Compuprint 9070 User Manual Page 110