147
If the message Remove paper appears on the display and no document is actually loaded in any
of the paper paths:
1. Check that no paper debris or dust is present in front of the paper detection sensors.
2. If necessary clean them with air blow. The figure shows how to clean the front path sensor,
and the rear path sensor.
Rear paper sensor
Front paper sensor
3. In case the Remove paper message is still displayed:
–
Power off the printer
–
Make sure no paper is loaded
–
Hold down the
Set-Up
button while powering the printer on.
The printer enters the Paper Sensor Tune mode and then displays:
1. Pap. sensor tune
2. Clear paper path
4. Press the
Sel/Save
button.
The printer initializes the paper detect sensors while the display shows Tuning sensor...
and then enters Ready state.
Comments to this Manuals