Compuprint 9060LA User Manual download pdf (Page 56)

When printing on adhesive labels you must disable the backward movement of the paper,

because the unsticking of the labels can cause paper jams when the paper is moved backwards.

Proceed as follows:

1. Press the

Set-Up

button to put the printer in Set-Up mode.

The display shows MACROS.

2. Press the ↓ button. MACRO X is displayed, where X is the number of the current Macro.

3. Press the ↓ button.

The display shows PROTOCOL.

4. Press the → button until the TEAR/VIEW MODE Option is displayed.

5. Press the ↓ button to pass over to the Values for the Tear/View mode.

6. Press the → or ← button, until No tear/reverse is displayed.

7. Press the

Sel/Save

button to set confirm the new setting. An asterisk is displayed to indicate

that the Value has been selected.

8. Press the

Exit

button to exit the Set-Up mode.

The message "Save config." appears, indicating that you are going to save your new

setting.

9. To permanently save your choice, press the

Sel/Save

button.

It is not necessary to perform the above operation when using the Push-Pull paper path, as all

backwards movements are inhibited with this path. We recommend using the Push-Pull path

when printing on adhesive labels, but note however that the printing of landscape barcodes may

generate backward movements.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 176 177

No comments

Compuprint 9060LA User Manual Page 56